User's Guide
Table Of Contents
- PTP 250 User Guide
- Safety and regulatory information
- Contents
- List of Figures
- List of Tables
- About This User Guide
- Chapter 1: Product description
- Chapter 2: Planning considerations
- Chapter 3: Legal information
- Chapter 4: Reference information
- Chapter 5: Installation
- Chapter 6: Configuration and alignment
- Chapter 7: Operation
- Chapter 8: Troubleshooting
- Testing link end hardware
- Testing when PoE LEDs do not illuminate correctly
- Testing after a lightning strike
- Test flowcharts
- AC LED is off
- AC LED is flashing
- PORT LED is off
- PORT LED is flashing
- Test Ethernet packet errors reported by ODU
- Test Ethernet packet errors reported by managed switch or router
- Test ping packet loss
- Test resistance in the ODU cable
- Testing the radio link
- Testing link end hardware
- Glossary
Notifications Chapter 4: Reference information
4-16
UNDER DEVELOPMENT
phn-2182_003v004 (Oct 2011)
Industry Canada (IC)
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B conforme á la norme NMB-003 du Canada.
RSS-GEN issue 3 (7.1.3) Licence-Exempt Radio Apparatus:
This device complies with Industry Canada license-exempt RSS standard(s). Operation
is subject to the following two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
In Canada, users should be cautioned to take note that high power radars are allocated as
primary users (meaning they have priority) of the 5650 – 5850 MHz spectrum and these
radars could cause interference and/or damage to license-exempt local area networks
(LELAN).
Product labels
FCC IDs and Industry Canada Certification Numbers are reproduced on the product label
(Figure 4-2).
Figu
re 4-2 FCC and IC certifications on 5.8 GHz product label
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1 This device may not cause harmful interference, and
2 This device must accept any interference received, including
interference that may cause undesired operation.
FCC ID:QWP58250
IC:109AO-58250
5.8 GHz European Union notification
PTP 250 units operating in the 5.8 GHz band are Class 2 devices as they operate on
frequencies that are not harmonized across the EU. Currently, only Denmark, Germany,
Eire (IRL), Norway, Spain and the UK allow the products to operate in the 5.8 GHz band.
However, the regulatory situation in Europe is changing and the radio spectrum may
become available in other countries in future. See www.ero.dk
for further information.
The operator is responsible for obtaining any national licenses required to operate these
products and these must be obtained before using the products in any particular country.