User's Guide
Table Of Contents
- PTP 250 User Guide
- Safety and regulatory information
- Contents
- List of Figures
- List of Tables
- About This User Guide
- Chapter 1: Product description
- Chapter 2: Planning considerations
- Chapter 3: Legal information
- Chapter 4: Reference information
- Chapter 5: Installation
- Chapter 6: Configuration and alignment
- Chapter 7: Operation
- Chapter 8: Troubleshooting
- Testing link end hardware
- Testing when PoE LEDs do not illuminate correctly
- Testing after a lightning strike
- Test flowcharts
- AC LED is off
- AC LED is flashing
- PORT LED is off
- PORT LED is flashing
- Test Ethernet packet errors reported by ODU
- Test Ethernet packet errors reported by managed switch or router
- Test ping packet loss
- Test resistance in the ODU cable
- Testing the radio link
- Testing link end hardware
- Glossary
PTP 250 User Guide
phn-2182_003v004 (Oct 2011)
UNDER DEVELOPMENT
4-1
Chapter 4: Reference information
This chapter describes the reference information and regulatory notices that apply to the
PTP 250.
The following reference topics are contained in this chapter:
• Equipment specifications on
page 4-2 contains specifications of the ODU and power
supply unit that are required for PTP 250 installations.
• Wireless specifications on page 4-5 cont
ains specifications of the PTP 250 wireless
interface, including RF bands, channel width and link loss.
• Data network specifications on
page 4-7 contains specifications of the PTP 250
Ethernet interface.
• Compliance with safe
ty standards on page 4-8 lists the safety specifications against
which the PTP 250 has been tested and certified. It also describes how to keep RF
exposure within safe limits.
• Compliance with radio regulations on page 4-12 describes
how the PTP 250 complies
with the radio regulations that are in force in various countries.
• Notifications on
page 4-14 contains notifications made to regulatory bodies for the
PTP 250.