User's Manual
Table Of Contents
- PTP 250 User Guide
- Copyrights
- Safety and regulatory information
- Contents
- List of Figures
- List of Tables
- About This User Guide
- Chapter 1 Product description
- Chapter 2 Planning considerations
- Chapter 3 Legal information
- Chapter 4 Reference information
- Chapter 5 Installation
- Chapter 6 Configuration and alignment
- Chapter 7 Operation
- Chapter 8 Troubleshooting
- Testing link end hardware
- Testing when PoE LEDs do not illuminate correctly
- Testing after a lightning strike
- Test flowcharts
- AC LED is off
- AC LED is flashing
- PORT LED is off
- PORT LED is flashing
- Test Ethernet packet errors reported by ODU
- Test Ethernet packet errors reported by managed switch or router
- Test ping packet loss
- Test resistance at the PoE end of the drop cable
- Testing the radio link
- Testing link end hardware
- Glossary
About
This
User Guide
phn-2182_002v000
May 2011
1
About This User Guide
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
.
.
.
.
This guide describes the planning, installation and operation of the Motorola PTP 250
Point-to-Point Wireless Ethernet Bridge. It is intended for use by the system designer,
system installer and system administrator.
Users of this guide should have knowledge of the following areas:
• Radio network design
• Outdoor radio equipment installation
• System installation, configuration, monitoring and fault finding
System designers should refer to the following chapters:
• Chapter 1 Product description
• Chapter 2 Planning considerations
• Chapter 3 Legal information
• Chapter 4 Reference information
In
stallers should refer to the following chapters:
• Chapter 5 Installation
• Chapter 6 Configuration and alignment
• Chapter 8 Troubleshooting
Oper
ators should refer to the following chapters:
• Chapter 1 Product description
• Chapter 6 Configuration and alignment
• Chapter 7 Operation
• Chapter 8 Troubleshooting