User's Manual
Table Of Contents
- PTP 250 User Guide
- Copyrights
- Safety and regulatory information
- Contents
- List of Figures
- List of Tables
- About This User Guide
- Chapter 1 Product description
- Chapter 2 Planning considerations
- Chapter 3 Legal information
- Chapter 4 Reference information
- Chapter 5 Installation
- Chapter 6 Configuration and alignment
- Chapter 7 Operation
- Chapter 8 Troubleshooting
- Testing link end hardware
- Testing when PoE LEDs do not illuminate correctly
- Testing after a lightning strike
- Test flowcharts
- AC LED is off
- AC LED is flashing
- PORT LED is off
- PORT LED is flashing
- Test Ethernet packet errors reported by ODU
- Test Ethernet packet errors reported by managed switch or router
- Test ping packet loss
- Test resistance at the PoE end of the drop cable
- Testing the radio link
- Testing link end hardware
- Glossary
Web-based management Chapter 7 Operation
phn-2182_002v000
7-8
May 2011
Viewing the system status
To display the System Status page, select menu option Status.
The System Status page (Figure 7-5) gi
ves the user a detailed view of the operation of
the system from both the wireless and network perspectives.
Figure 7-5 System Status page
The page is subdivided into three sections:
• Equipment: This contains the unit’s inventory and identification information.
• LAN: This describes the unit’s network identity and connectivity.
• Wireless: This presents the key wireless metrics, which are displayed as a series
of measurements.