User's Manual
Table Of Contents
- PTP 250 User Guide
- Copyrights
- Safety and regulatory information
- Contents
- List of Figures
- List of Tables
- About This User Guide
- Chapter 1 Product description
- Chapter 2 Planning considerations
- Chapter 3 Legal information
- Chapter 4 Reference information
- Chapter 5 Installation
- Chapter 6 Configuration and alignment
- Chapter 7 Operation
- Chapter 8 Troubleshooting
- Testing link end hardware
- Testing when PoE LEDs do not illuminate correctly
- Testing after a lightning strike
- Test flowcharts
- AC LED is off
- AC LED is flashing
- PORT LED is off
- PORT LED is flashing
- Test Ethernet packet errors reported by ODU
- Test Ethernet packet errors reported by managed switch or router
- Test ping packet loss
- Test resistance at the PoE end of the drop cable
- Testing the radio link
- Testing link end hardware
- Glossary
Aligning antennas Chapter 6 Configuration and alignment
phn-2182_002v000
6-30
May 2011
Disarming the units
When antenna alignment is complete, both units in the link must be disarmed before
network connection.
To disarm the units, select menu option Installation Wizard. The Step 5: Confirm
Configuration page is displayed (Figure 6-14). Select Se
t Disarmed, Yes to confirm
and then Back until the Step 1: LAN Configuration page is displayed.