User's Manual

Using the installation wizard Chapter 6 Configuration and alignment
phn-2182_002v000
6-20
May 2011
Step 3: Date and time settings
Step 3 of the Installation wizard is for setting the date and time (Figure 6-17). The
attributes are described in Table 6-3. Update t
he attributes as required and select
Next.
The clock supplies accurate date and time information to the system. It can be set to
run with or without a connection to a Network Time Protocol (NTP) server:
• In the absence of an NTP server connection, the clock can be set to run manually.
The clock is battery backed and will continue to operate for several days after the
ODU is switched off.
• If an NTP server connection is available, the clock can be set to synchronize with
the server time at regular intervals.
Figure 6-17 Step 3: Date and Time Settings page