User's Manual
Table Of Contents
- PTP 250 User Guide
- Copyrights
- Safety and regulatory information
- Contents
- List of Figures
- List of Tables
- About This User Guide
- Chapter 1 Product description
- Chapter 2 Planning considerations
- Chapter 3 Legal information
- Chapter 4 Reference information
- Chapter 5 Installation
- Chapter 6 Configuration and alignment
- Chapter 7 Operation
- Chapter 8 Troubleshooting
- Testing link end hardware
- Testing when PoE LEDs do not illuminate correctly
- Testing after a lightning strike
- Test flowcharts
- AC LED is off
- AC LED is flashing
- PORT LED is off
- PORT LED is flashing
- Test Ethernet packet errors reported by ODU
- Test Ethernet packet errors reported by managed switch or router
- Test ping packet loss
- Test resistance at the PoE end of the drop cable
- Testing the radio link
- Testing link end hardware
- Glossary
PTP 250 User Guide Using the installation wizard
phn-2182_002v000
May 2011
6-17
Step 2: Wireless configuration
Step 2 of the Installation wizard is for updating the wireless configuration (Figure
6-16). The attributes are described in Table 6-2. Update t
he attributes as required and
select Next.
Figure 6-16 Step 2: Wireless Configuration page
NOTE
When installing connectorized units, ensure that Antenna Gain, Cable Loss
and Maximum Power Level are within regulatory limits. For more
information, refer to Calculating EIRP for connectorized units on
page 4-30.