User's Manual
Table Of Contents
- PTP 250 User Guide
- Copyrights
- Safety and regulatory information
- Contents
- List of Figures
- List of Tables
- About This User Guide
- Chapter 1 Product description
- Chapter 2 Planning considerations
- Chapter 3 Legal information
- Chapter 4 Reference information
- Chapter 5 Installation
- Chapter 6 Configuration and alignment
- Chapter 7 Operation
- Chapter 8 Troubleshooting
- Testing link end hardware
- Testing when PoE LEDs do not illuminate correctly
- Testing after a lightning strike
- Test flowcharts
- AC LED is off
- AC LED is flashing
- PORT LED is off
- PORT LED is flashing
- Test Ethernet packet errors reported by ODU
- Test Ethernet packet errors reported by managed switch or router
- Test ping packet loss
- Test resistance at the PoE end of the drop cable
- Testing the radio link
- Testing link end hardware
- Glossary
Using the installation wizard Chapter 6 Configuration and alignment
phn-2182_002v000
6-14
May 2011
Using the installation wizard
Perform this task to configure the LAN, wireless, date and email attributes of the unit.
This task consists of the following procedures:
• Starting installation wizard on
page 6-14
• Step 1: LAN configuration on pa
ge 6-15
• Step 2: Wireless configuration on
page 6-17
• Step 3: Date and time settings on pag
e 6-20
• Step 4: Email configuration on
page 6-22
• Step 5: Confirm installation configuration on
page 6-23
Starting installation wizard
To start the installation wizard, select menu option Installation Wizard. The
response depends upon the state of the unit:
• If the unit is armed for alignment, the Step 5: Confirm Configuration page is
displayed (Figure 6-14). Select Se
t Disarmed, Yes to confirm and then Back
until the Step 1: LAN Configuration page is displayed.
• If the unit is not armed, the Step 1: LAN Configuration page is displayed.
Figure 6-14 Step 5: Confirm Configuration page (when unit is armed)