User's Manual
Table Of Contents
- PTP 250 User Guide
- Copyrights
- Safety and regulatory information
- Contents
- List of Figures
- List of Tables
- About This User Guide
- Chapter 1 Product description
- Chapter 2 Planning considerations
- Chapter 3 Legal information
- Chapter 4 Reference information
- Chapter 5 Installation
- Chapter 6 Configuration and alignment
- Chapter 7 Operation
- Chapter 8 Troubleshooting
- Testing link end hardware
- Testing when PoE LEDs do not illuminate correctly
- Testing after a lightning strike
- Test flowcharts
- AC LED is off
- AC LED is flashing
- PORT LED is off
- PORT LED is flashing
- Test Ethernet packet errors reported by ODU
- Test Ethernet packet errors reported by managed switch or router
- Test ping packet loss
- Test resistance at the PoE end of the drop cable
- Testing the radio link
- Testing link end hardware
- Glossary
Installing the PoE power supply Chapter 5 Installation
phn-2182_002v000
5-28
May 2011
Mounting the PoE power supply
To mount the PTP 250 PoE power supply: install two screws (Table 5-1) in the wall or
shelf, then align the mounting slots (Figure 5-12) to capt
ure the surface screws.
Figure 5-12 Mounting slots on underside of PoE power supply
Table 5-1 Screw dimensions for the PoE power supply