User's Manual

Notifications Chapter 4 Reference information
phn-2182_002v000
4-34
May 2011
This device complies with part 15 of the US FCC Rules and Regulations and with
RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause undesired operation. In
Canada, users should be cautioned to take note that high power radars are allocated
as primary users (meaning they have priority) of the 5650 – 5850 MHz spectrum and
these radars could cause interference and/or damage to license-exempt local area
networks (LELAN).
For the connectorized version of the product and in order to reduce potential radio
interference to other users, the antenna type and its gain should be so chosen that the
Effective Isotropically Radiated Power (EIRP) is not more than that permitted for
successful communication.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the US FCC Rules and with RSS-210 of Industry
Canada. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can
radiate radio-frequency energy and, if not installed and used in accordance with these
instructions, may cause harmful interference to radio communications. If this
equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment on and off, the user is encouraged to correct
the interference by one or more of the following measures:
• Increase the separation between the affected equipment and the unit;
• Connect the affected equipment to a power outlet on a different circuit from that
which the receiver is connected to;
• Consult the dealer and/or experienced radio/TV technician for help.
FCC IDs and Industry Canada Certification Numbers are reproduced on the product
label (Figure 4-2).
Figu
re 4-2 FCC and IC certifications on 5.8 GHz product label
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1 This device may not cause harmful interference, and
2 This device must accept any interference received, including
interference that may cause undesired operation.
FCC ID:QWP58250
IC:109AO-58250