User's Manual
Table Of Contents
- PTP 250 User Guide
- Copyrights
- Safety and regulatory information
- Contents
- List of Figures
- List of Tables
- About This User Guide
- Chapter 1 Product description
- Chapter 2 Planning considerations
- Chapter 3 Legal information
- Chapter 4 Reference information
- Chapter 5 Installation
- Chapter 6 Configuration and alignment
- Chapter 7 Operation
- Chapter 8 Troubleshooting
- Testing link end hardware
- Testing when PoE LEDs do not illuminate correctly
- Testing after a lightning strike
- Test flowcharts
- AC LED is off
- AC LED is flashing
- PORT LED is off
- PORT LED is flashing
- Test Ethernet packet errors reported by ODU
- Test Ethernet packet errors reported by managed switch or router
- Test ping packet loss
- Test resistance at the PoE end of the drop cable
- Testing the radio link
- Testing link end hardware
- Glossary
Contents
phn-2182_002v000
vi
May 2011
Connecting an RJ45 and gland to a unit ........................................................................... 5-19
Disconnecting an RJ45 and gland from a unit .................................................................. 5-21
Making a drop cable ground point .................................................................................... 5-22
Installing and grounding the drop cable at building entry ............................................... 5-25
Installing the PoE power supply ............................................................................................. 5-27
Preparing for PoE power supply installation .................................................................... 5-27
Mounting the PoE power supply ....................................................................................... 5-28
Connecting the PoE power supply to the drop cable ........................................................ 5-29
Preparing the PoE power supply to network equipment cable ......................................... 5-30
Chapter 6 Configuration and alignment ........................................................................ 6-1
Preparing for configuration and alignment .............................................................................. 6-2
Safety precautions during configuration and alignment .................................................... 6-2
Regulatory compliance during configuration and alignment ............................................. 6-2
Selecting configuration options .......................................................................................... 6-2
Connecting to the unit .............................................................................................................. 6-3
Configuring the management PC ........................................................................................ 6-3
Connecting to the PC and powering up .............................................................................. 6-5
Logging into the web interface ........................................................................................... 6-6
Upgrading firmware version ................................................................................................... 6-10
Checking the installed firmware version .......................................................................... 6-10
Saving the system configuration ....................................................................................... 6-11
Uploading a new firmware version ................................................................................... 6-12
Using the installation wizard .................................................................................................. 6-14
Starting installation wizard ............................................................................................... 6-14
Step 1: LAN configuration ................................................................................................ 6-15
Step 2: Wireless configuration .......................................................................................... 6-17
Step 3: Date and time settings .......................................................................................... 6-20
Step 4: Email configuration .............................................................................................. 6-22
Step 5: Confirm installation configuration ........................................................................ 6-23
Aligning antennas ................................................................................................................... 6-24
Starting up the units ......................................................................................................... 6-24
Checking that the units are armed ................................................................................... 6-25
Aligning antennas ............................................................................................................. 6-25
Aligning separate antennas for spatial diversity .............................................................. 6-27