User's Guide Part 2

Installing PTP-SYNC Chapter 5 Installation
phn-0896_009v003
5-36
UNDER DEVELOPMENT
Feb 2010
Installing PTP-SYNC
Recommended kit
PTP-SYNC kit
The PTP-SYNC kit (Figure 5-12) contains the following components:
• 1 x PTP-SYNC unit
• 1 x M4 pan screw
• 2 x M4 washers
• 2 x M3 (6mm) torx drive screws
• 1 x lug for unit earth (cable not supplied)
Figure 5-12 PTP-SYNC kit
GPS timing kit
The GPS receiver module is an optional item that must be purchased separately, if the
chosen PTP-SYNC system configuration includes GPS.