User's Guide Part 2

Installing the GPS receiver for PTP-SYNC Chapter 5 Installation
phn-0896_009v003
5-30
UNDER DEVELOPMENT
Feb 2010
Figure 5-11 RJ45 and Trimble connector pins
Mounting the GPS receiver
Mount the GPS receiver (following manufacturer’s instructions) upon either an
external wall or a metal tower or mast. Motorola recommends that the receiver is wall
mounted. For more information on these options, refer to Protection of the GPS
receiver f
or PTP-SYNC on page 2-36.
Connecting the GPS receiver to the drop cable
The drop cable must be connected the GPS receiver using the Trimble connector
provided.
CAUTION
The supported Superior Essex cable has solid copper conductors. There is a
limited number of times each conductor can be bent before it fatigues and
fails.
To fit the Trimble 12-pin connector to the drop cable, proceed as follows: