User's Guide Part 2

User Guide: PTP 600 Series Mounting the ODUs
phn-0896_009v003
Feb 2010
UNDER DEVELOPMENT
5-21
ODU mounting procedure
WARNING
To prevent failure of the assembly, observe the following precautions
when mounting the ODU:
o Do not remove the pre-fitted mounting bracket from the ODU.
o Do not mount the ODU on poles with diameter less than 50mm (2”) or
greater than 75mm (3”). The ODU mounting bracket is designed to work
only with poles with diameter in the 50 mm (2”) to 75 mm (3”) range.
o Do not over-tighten the bolts.
The ODU must be mounted using the following steps, ensuring that the cable entry is
at the bottom:
Procedure 5-10 Mounting the ODU
1
Attach the bracket strap to the pole using M8 x 70 mm bolts, M8 flat washers
and M8 coil washers. Tighten to ensure the assembly grips but can be adjusted.
2
Offer the ODU (with pre-fitted mounting bracket) to the bracket strap and affix
using the captive M8 bolt. Tighten to ensure the assembly grips, but can be
adjusted on the pole.