User's Guide Part 2

User Guide: PTP 600 Series Preparing for site installation
phn-0896_009v003
Feb 2010
UNDER DEVELOPMENT
5-7
Preparing for site installation
Checks
Before proceeding with the installation, perform the following checks:
• Plan the link, as described in Chapter 2 Planning considerations.
• Check t
he configuration of the Master and Slave units, as described in Checking
th
e configuration on page 5-2.
• Check
the contents of all packages against the parts lists shown in the packing
list.
• Ensure that qualified installers are available to undertake the work.
• Ensure that the correct safety precautions are observed.
Tools required
The following specific tools are required to install a PTP 600 Series, in addition to
general tools:
• 13mm wrench and 22 mm wrench for use with the glands
• RJ45 crimp tool (it must be the correct tool for the type of RJ45 being used)
• Personal Computer (PC) with 10, 100 or 1000 BaseT Ethernet
• Either Internet Explorer version 6 or higher, or FireFox 2.0 or higher are
recommended.
• Ethernet patch cables
• Motorola PTP LINKPlanner report for this link