User's Guide Part 2

Checking the configuration Chapter 5 Installation
phn-0896_009v003
5-4
UNDER DEVELOPMENT
Feb 2010
Opening the web interface
When the unit has been powered up and connected to the management PC, the web
interface can be opened. To open the PTP 600 web interface on the management PC,
proceed as follows:
Procedure 5-2 Open the web interface
1
Start the web browser.
2
Type the IP address of the unit into the address frame, for example:
169.254.1.2.
3
Press ENTER. The login page (
Figure 6-7) is displayed.
4
Leave the Password blank and select Login. The web interface menu
(Figure 6-1) and System Summary page (Figure 6-2) are displayed.
Checking LAN configuration
The unit must be configured to be compatible with the network. It is particularly
important to avoid IP address conflicts. To check the LAN configuration, proceed as
follows:
Procedure 5-3 Check LAN configuration
1
Design the desired configuration of the network to be installed, noting the
required IP Address, Subnet Mask and Gateway IP Address of the Master
and Slave units.
2
Select LAN Configuration from the menu. The LAN Configuration page
(Figure 6-20) is displayed.
3
Compare the required IP Address, Subnet Mask and Gateway IP Address to
current settings.
4
If the current settings are different, update them as described in
Configuring the IP and Ethernet interfaces on page 6-42.