User's Guide Part 2

User Guide: PTP 600 Series Checking the configuration
phn-0896_009v003
Feb 2010
UNDER DEVELOPMENT
5-3
Powering up and connecting the PIDU Plus
When the management PC has been configured with the correct IP address and subnet
mask, the PIDU can be powered up and connected to the management PC. To power
up the PIDU and connect it to the PC, proceed as follows:
Procedure 5-1 Power up and connect the PIDU Plus
1
Apply mains or battery power to the PIDU Plus. The green Power LED
should illuminate continuously.
2
After 45 seconds, the orange Ethernet LED should be observed starting
with 10 slow flashes.
3
Connect the CAT5e cable from the LAN port of the PIDU Plus to the
management PC (either via the network or directly using a standard CAT5
patch cable). The Ethernet LED should blink randomly as traffic passes
through.
4
If the Power and Ethernet LEDs do not illuminate correctly, refer to
Test
link end hardware
on page 7-2.