User's Guide Part 2

User Guide: PTP 600 Series Using recovery mode
phn-0896_009v003
Feb 2010
UNDER DEVELOPMENT
7-25
Figure 7-13 Reboot confirmation pop up
The unit will now reboot. The unit should now start up in normal mode but with the IP
address set to 169.254.1.1 and the Ethernet interface set to auto-negotiate and auto-
MDI/MDIX. If the unit fails to recover, refer to Test link end hardware on
page 7-2.
Erase configuration
To erase the unit’s configuration the user should press the “Erase Configuration”
button on the “Recovery Options” page (Figure 7-7). Th
e user will now be presented
with a pop up box asking them to confirm the action (Figure 7-14).
Fi
gure 7-14 Confirm erase configuration pop up