User's Guide Part 2

User Guide: PTP 600 Series Using recovery mode
phn-0896_009v003
Feb 2010
UNDER DEVELOPMENT
7-23
Figure 7-9 Software Upgrade Complete page
After carefully checking that correct image has been downloaded the user should
reboot the unit by pressing the “Reboot Wireless Unit” button. The user will then be
presented with a pop up box asking them to confirm the action (Figure 7-10).
Fi
gure 7-10 Reboot confirmation pop up
The unit will now reboot. Providing the unit configuration is still intact the unit should
restart in normal operational mode and the link should recover. If the unit or link fails
to recover, refer to Test link end hardware on pag
e 7-2.
Reset IP & Ethernet configuration
To reset IP & Ethernet configuration back to factory defaults the user should press the
“Reset IP & Ethernet Configuration back to factory defaults” button on the “Recovery
Options” page (
2Figure 7-7). The user will now be presented with a pop up box asking
them to confirm the action (Figure 7-11).