User's Guide Part 2

Managing faults Chapter 6 Operation
phn-0896_009v003
6-116
UNDER DEVELOPMENT
Feb 2010
Attribute Meaning
SNMP Trap IP Address
Enter the IP address that will receive all SNMP traps.
This will normally be the network management system,
but it may be a separate trap receiver.
To disable trap generation, enter 0.0.0.0 in the IP
Address.
SNMP Trap Port
Number
Enter the port number of either the networked SNMP
manager or trap receiver. By convention, the default port
number is 162.
SNMP Community
String
The SNMP community string acts like a password
between the network management system and the
distributed SNMP clients (PTP 800 CMUs). Only if the
community string is configured correctly on all SNMP
entities can the flow of management information take
place. By convention the default value is set to ‘public’.
SNMP Port Number
Enter the port that the SNMP agent is listening to for
commands from a management system. By convention,
the default port number is 161.
WiMAX Control
Enables and Disables the WiMAX (802.16) MIB. This
control is only displayed when ‘Fixed Frequency’ is
selected during installation.
SMTP (Simple Mail Transport Protocol)
The SMTP client is an alternative method for the PTP 600 Series to alert a system
administrator when there are or have been system errors:
SMTP Email Alert
This attribute controls the activation of the SMTP client.
SMTP Enabled Messages
The SMTP Enabled Messages attribute controls which email alerts the unit will send.
SMTP IP Address
The IP address of the networked SMTP server.
SMTP Port Number
The SMTP Port Number is the port number used by the networked SMTP server. By
convention the default value for the port number is 25.