User's Guide Part 2

User Guide: PTP 600 Series Upgrading the PTP 600
phn-0896_009v003
Feb 2010
UNDER DEVELOPMENT
6-85
5
Select Program Software Image into Non-Volatile Memory. The Progress
Tracker page is displayed (
Figure 6-47). The upgrade process should not be
interrupted, as this can result in a corrupt main software image, which will result in
the recovery image been booted at the next reset cycle.
On completion, the Software Upgrade Complete page is displayed (
Figure 6-48).
6
Select Reboot Wireless Unit. Select OK to confirm (
Figure 6-49). The unit reboots
with the new software installed.
The reboot process will take up to 120 seconds. During this time it will not be
possible to communicate with the unit.
7
After the reboot, check that the required software image is loaded and running
.
NOTE
If communication with the unit is not restored after 120 seconds , this could
indicate a problem with the memory update process. If this happens, enter
“Recovery Mode” as described in Using recovery mode on
page 7-20.
Figure 6-45 Software Upgrade page