User's Guide Part 2

User Guide: PTP 600 Series Upgrading the PTP 600
phn-0896_009v003
Feb 2010
UNDER DEVELOPMENT
6-81
Saving and restoring system configuration
The save and restore feature allows the system administrator to save and restore the
operational configuration of the units. Motorola recommends that the configuration
should be saved immediately after a successful link installation and immediately before
a software upgrade. In the unlikely event that a unit has to be replaced in the field, the
replacement unit can be reconfigured by restoring the saved configuration file.
Saving the configuration file
Perform this task to save the operational configuration of the units.
To save the configuration file, proceed as follows:
Procedure 6-4 Save configuration file
1
From the left hand menu, select Configuration, Save And Restore. The Save &
Restore Configuration page is displayed (Figure 6-44).
2
Select Save Configuration File.
3
Save the configuration file to a PC hard drive.
The configuration file format is:
MAC-mm-mm-mm_IP-iii-iii-iii-iii.cfg
Where: Is:
mm-mm-mm MAC address of unit
iii-iii-iii-iii IP address of unit.