User's Guide Part 2

User Guide: PTP 600 Series Installation pages
phn-0896_009v003
Feb 2010
UNDER DEVELOPMENT
6-73
When Section Installation step 3 - confirm configuration on
page 6-69 is complete, the
installation is armed and rebooted. Pressing the “Disarm Installation Agent” button
completes the installation process and the audible installation tone will be switched
off. If the installer wishes to modify the installation configuration then the ‘Back’ link
can be used to access the installation wizard steps described above.
The installation process is completed when both ends of the link are ‘disarmed’.
After disarming the wireless link the user is presented with one of two possible
configuration pages, see Figure 6-37 and Figure 6-38. T
he screen presents hyperlinks
to the main configuration and spectrum management pages.
Figure 6-37 Optional post disarm configuration 1
Figure 6-38 Optional post disarm configuration 2
After installation the system administrator may wish to modify the wireless units
descriptive configuration (link name and link location). In addition the system
administrator may wish to change the spectrum management configuration of the
wireless unit, or look at the analysis of the 5.8 GHz spectrum to see if the automatic
channel selection is appropriate for the system administrator’s network. It is also
recommended that a backup copy of the wireless units configuration is taken.
Hyperlinks are provided on the post disarm page for ease of use.