User's Guide Part 2

Installation pages Chapter 6 Operation
phn-0896_009v003
6-66
UNDER DEVELOPMENT
Feb 2010
TDD synchronization configuration
TDD synchronization is enabled and configured using the install wizard during the
installation process of the link.
TDD synchronization enable
To enable TDD Synchronization, set the TDD Synchronization Mode attribute to
‘Enabled’ (Figure 6-31).
Wh
en TDD Synchronization is enabled, the following restrictions apply:
• Ranging Mode and Target Range are disabled.
• Link Symmetry is forced to ‘1:1’ operation only.
TDD synchronization configuration
When TDD Synchronization is enabled, there is an extra installation screen (“TDD
Synchronization”, Figure 6-33).
Fi
gure 6-33 Step 3: TDD Synchronization page