User's Guide Part 2

User Guide: PTP 600 Series Installation pages
phn-0896_009v003
Feb 2010
UNDER DEVELOPMENT
6-65
Tx Color Code, Rx Color Code
The Tx Color Code and Rx Color Code attributes need only be considered when the
unit is installed in a dense network of synchronized PTP 600 units and where some of
the PTP 600 units are operating on the same frequency. In this case, the value would
normally be derived by a network radio planner. In all other cases, it is strongly
recommended that this attribute is left at the default value of "A".
NOTE
The value of Tx Color Code MUST always match the value of Rx Color Code
at the other end of the link.
Automatic Tx Power Control
Leave this attribute at the default setting ‘Disabled’.
Installation Tones
Where the use of audio installation tones is not required, this control allows the
installer to optionally disable the tone generator during the installation process.
Figure 6-32 Step 2: Wireless Configuration page (extract) for fixed frequency
Submit wireless configuration
Once the installer is satisfied with the wireless configuration options then the Submit
Wireless Configuration button or the Next link should be clicked.