User's Guide Part 2

Installation pages Chapter 6 Operation
phn-0896_009v003
6-52
UNDER DEVELOPMENT
Feb 2010
License Key License Key
A471-FE88-428D-E1F3 534F-4F54-D1B0-E2DA
IP Address IP Address
169.254.1.2 169.254.1.1
CAUTION
The factory default configuration is limited in range to 40 Km (25 miles). If
you wish to install a wireless link with a range of > 40 Km (> 25 miles) and
< 200 Km (< 124 miles) or < 5 Km (< 3 miles) you must follow Manual
co
nfiguration on page 6-52.
The f
actory default configuration is set to Region 1. Region 1 allows the PTP
600 Series a maximum transmit power of 25 dBm. If the local regulatory
regime limits the maximum transmit power (EIRP) to less than 25 dBm, you
should obtain a new license key containing the correct region code from
your local distributor or direct from Motorola. Alternatively in the short
term, you should reduce the maximum transmit power by following the
procedures in Manual configuration on
page 6-52.
Manual configuration
If the installer / system administrator wishes, they may modify the default installation
configuration. If only the IP addresses (network configuration) are incorrect it is
recommended that the values are changed via the configuration menu, as described in
LAN configuration on
page 6-42.
NOTE
If any other parameters (for example region code) require modification, then
it is recommended that the system administrator use the Installation Wizard.
The PTP 600 Series operational software requires a license key (Figure 6-26) to
enable
the wireless bridging capability and programs region code specific parameters in to
the unit.