User's Guide Part 2

User Guide: PTP 600 Series Configuring the PTP 600
phn-0896_009v003
Feb 2010
UNDER DEVELOPMENT
6-49
Configuring the telecoms circuits
The Telecoms page (Figure 6-25) is available when the Telecoms Interface has been
set to either T1 or E1 in the Installation Wizard.
The unit displays the interface setting and line code for the available telecoms
channels. The PTP 600 Series is able to support two T1 or E1 channels. These channels
are referred to as "Channel A" and "Channel B".
The "Channel B" configuration and controls will be displayed only when the second
channel is enabled.
Figure 6-25 Telecoms page
The Telecoms page contains the following fields:
Telecoms Interface
May be either T1 or E1, reflecting the Installation Wizard setting.
Line Code
Displays the Line Code setting for each channel. The Line Code configuration must
match the configuration of the connected equipment and may be set using the
Installation Wizard.