User's Guide Part 2

User Guide: PTP 600 Series Configuring the PTP 600
phn-0896_009v003
Feb 2010
UNDER DEVELOPMENT
6-45
Figure 6-22 Configuration Reboot page - Ethernet auto negotiation disabled
This will be followed by a pop-up dialogue box asking to confirm the action.
NOTE
At this point you will lose connection to the unit. If you have just changed the
IP Address, you now have to reconnect to the unit using the address just set.
LAN configuration page for VLAN
The layout of the LAN Configuration page changes if this attribute is enabled in order
to allow the VLAN VID and VLAN Priority to be set, see Figure 6-23. The
VLAN
settings are applied only after the unit is rebooted.
CAUTION
You must ensure that you can access the VLAN which you configure here,
otherwise you will be unable to access the unit following the next reboot.
The PTP 600 management function is only compatible with single VLAN
tagged packets. Any management packet with two or more packets will be
ignored.