User's Guide Part 1

User Guide: PTP 600 Series PTP 58600 reference information
phn-0896_009v003
Feb 2010
UNDER DEVELOPMENT
4-85
PTP 58600 FCC antenna restrictions
In FCC regions, external antennas from the lists in Table 4-55 and Table 4-56 can be
used with the Connectorized version of the PTP 58600. These are approved by the FCC
for use with the product and are constrained by the following limit for Single/Dual
Polarization Parabolic Dish Antennas: up to 37.7 dBi per polarization or antenna.
In FCC regions when using external antennas, cable loss between the connectorized
version of the PTP 600 Series and the antenna ports must not be less than 1.2 dB.
CAUTION
Antennas not included in this table, or those having a gain greater than the
specified maximum, are strictly prohibited for use with the PTP 58600. The
required antenna impedance is 50 ohms.
Table 4-55 Allowed antennas for deployment in USA/Canada – 5.8 GHz
Manufacturer Antenna Type
Gain
(dBi)
Flat
Plate
Parabolic
Dish
Andrew Andrew 1-foot Flat Panel, FPA5250D12-N
(23.6dBi)
23.6 Y
Andrew Andrew 2-foot Flat Panel, FPA5250D24-N
(28dBi)
28 Y
Gabriel Gabriel 1-foot Flat Panel, DFPD1-52
(23.5dBi)
23.5 Y
Gabriel Gabriel 2-foot Flat Panel, DFPD2-52
(28dBi)
28 Y
MTI MTI 17 inch Diamond Flat Panel, MT-
485009 (23dBi)
23 Y
MTI MTI 15 inch Dual-Pol Flat Panel,
MT-485025/NVH (23dBi)
23 Y
MTI MTI 2 ft Directional Flat Panel, MT-20004
(28dBi)
28 Y
MTI MTI 2 ft Flat Panel, MT-486001 (28dBi) 28 Y