User Manual

Web Page Reference

Example PTP 500 Series Conﬁguration

Data

For your convenience these two units have been

pre-conﬁgured as a link Units

Units:

ODU serial number ODU serial number

0167100000A0 016710000096

Ethernet MAC address Ethernet MAC address

00:04:56:10:00:96 00:04:56:10:00:A0

Conﬁgured as:

Master Slave

Target MAC address Target MAC address

00:04:56:10:00:A0 00:04:56:10:00:96

License key License Key

0557-D8B0-47A1-B0DD 534F-4F54-D1B0-E2DA

IP Address IP Address

169.254.1.2 169.254.1.1

Table 12 500 Series Bridge

Factory Conﬁguration Values

The factory default conﬁguration is limited in range to 40 Km (25 miles). If you wish to install a

wireless link with a range of > 40 Km (> 25 miles) and < 200 Km (< 124 miles) or < 5Km(< 3

miles) you must follow the steps in Section 8.3.4.1 “Manually Conﬁguring The Wireless Units”.

The factory default conﬁguration is set to Region 26. Region 26 allows the 500 Series bridge a

maximum transmit power of 25 dBm. If the local regulatory regime limits the maximum transmit

power (EIRP) to less than 25 dBm you should obtain a new license key containing the correct

region code from your local distributor or direct from Motorola. Alternatively in the short term,

you should reduce the maximum transmit power by following the procedures in Section 8.3.4.1

“Manually Conﬁguring The Wireless Units”.

8.3.4.1 Manually Conﬁguring The Wireless Units

If the installer / system administrator wishes, they may modify the default installation conﬁgu-

ration. If only the IP addresses (network conﬁguration) are incorrect it is recommended that the

values are changed via the conﬁguration menu (Section 8.3.1.2 “LAN Conﬁguration Page”). If