User Manual

Web Page Reference
67
Figure 30 System Configuration Page
While the majority of the system configuration is entered during installation and should never
require changing, this page offers the system administrator the ability to change the basic system
parameters for both the wireless and Ethernet components.
Link Name: User defined identity for the unit (max 63 characters).
Link Location: Can be used as a generic scratch pad to describe the location of the equipment.
Master Slave Mode and Link Mode Optimization current settings are displayed and can be
modified using the Installation Wizard pages. See Section 8.3.4 “Install Pages”
Max Receive Modulation Mode: This is the maximum mode the unit will use as its adaptive
modulation. By default the Max Receive Modulation Mode is the highest mode available.
For minimum error rates on TDM links the user should set the maximum modulation mode to
64QAM 0.75 at both ends of the link.
Ethernet Capped Max Wireless Speed: When enabled this option will cap the wireless speed
to a mode that the connected Ethernet connection can sustain.
Maximum Transmit Power: This specifies the maximum transmit power in dBm of the system.
It is country dependent and although the user can change this in 1dB steps, it will be limited to
that country’s regulations
13
.
In the UK there is a legal requirement to provide a minimum of 19dB of transmit power control range. When the
13
equipment is operating with a UK License Key, an additional facility is provided on the configuration page that
allows the transmitted power to be reduced by 19dB compared to the maximum allowed with a simple single step
control.