User Manual

Web Page Reference

Receive Modulation Mode: The modulation mode currently being used on the receive channel.

List of all the modulation modes can be found in Section 14 where data rate calculations plots

are given for each available modulation mode.

Receive Modulation Mode Detail: This supplies the user with information regarding the

receive modulation mode in use. Possible values are:

• Running at maximum receive mode

• Running at user-conﬁgured Max Modulation Mode

• Restricted due to byte errors on the wireless link or local Ethernet Tx Fifo Drops

• Restricted because a DFS channel change is in progress

• Restricted due to telecoms acquisition mode

• Restricted due to the low Ethernet link speed

• Limited by the wireless conditions

Range: The range

between the 500 Series bridge ODUs.

8.3 System Administration Pages

The following menu options are available for the system administrator and can be password pro-

tected. Figure 29 shows the system administration login page. By default a system administrator

password is not set. Simply click the login button to access the system administration features.

Figure 29 System Administration Login Page

Once the password has been set using the ‘Change Password’ menu item the system administration

pages will only be available after the user has entered the correct password.

The features that are only available to the system administrator are:

• Conﬁguration

• Statistics

• The Installation Wizard

• Software Upgrade

The PTP 500 Series Bridge displays range in km by default, if the user would prefer to display range using Miles the

‘Distance Units’ attribute should be set to imperial, see the “Properties” web page Section 8.3.14 “Properties”.