User Manual

Installation
51
7.7.3 Making the PTP 500 Series Bridge PIDU Plus Connection At The ODU
The following procedure describes how connection is made at the ODU. It is often easier to carry
out this procedure on the ground or a suitable surface prior to mounting the ODU.
Ensure that no power is connected to the PIDU Plus or present on the cable before connecting the
ODU.
Step 1: Assemble the cable
as described in 5.7.1 above
Step 2: Insert the RJ45 connector making
sure that the locking tab snaps home
Step 3: Screw in the body of the
weather proofing gland and tighten
Step 4: Screw on the clamping nut and tighten
(Do not over tighten – see Figure 19)
Figure 21 Connecting the PIDU+ to the ODU