User Manual

Recovery Mode
125
Recovery Reason:Indicates the reason the unit is operating in Recovery mode. Possible reasons
are “Recovery button active” or “Invalid or corrupt image”
MAC Address:The MAC address shown here is the MAC address of the unit programmed during
manufacture.
9.1 Upgrade Software Image
The first step (Figure 81) is to use the ‘Browse’ button to locate the software image to be
downloaded. Once located the user should press the “Upgrade Software Image” button to start
the software download process.
During software download, progress is indicated by a pair of progress bars (Figure 82).
Figure 82 Software Download Progress Indicator Page
When the download is complete a page is displayed indicating the status of the software download
(Figure 83).
Figure 83 Software Download Complete Page
After carefully checking that correct image has been downloaded the user should reboot the unit
by pressing the “Reboot Wireless Unit” button. The user will then be presented with a pop up
box asking them to confirm the action (Figure 84)
The unit will now reboot. Providing the unit configuration is still intact the unit should restart in
normal operational mode and the link should recover. Should the unit or link fail to recover the
user should refer to Section 10 “Fault Finding”.