User's Manual Part 1
Table Of Contents
- Cambium PTP 650 Series User Guide
- Contacting Cambium Networks
- Purpose
- Cross references
- Feedback
- Chapter 1: Product description
- Chapter 2: System hardware
- Chapter 3: System planning
- Chapter 4: Legal and regulatory information
- Cambium Networks end user license agreement
- Acceptance of this agreement
- Definitions
- Grant of license
- Conditions of use
- Title and restrictions
- Confidentiality
- Right to use Cambium’s name
- Transfer
- Updates
- Maintenance
- Disclaimer
- Limitation of liability
- U.S. government
- Term of license
- Governing law
- Assignment
- Survival of provisions
- Entire agreement
- Third party software
- Compliance with safety standards
- Compliance with radio regulations
- Cambium Networks end user license agreement
Chapter 3: System planning Typical deployment
Typical deployment
This section contains diagrams illustrating typical PTP 650 site deployments.
ODU with POE interface to PSU
In the basic configuration, there is only one Ethernet interface, a copper Cat5e power over Ethernet
(POE) from the PSU to the ODU (PSU port), as shown in the following diagrams: mast or tower
installation (Figure 23 ), wall installation (Figure 24) and roof installation (Figure 25).
Figure 23
Mast or tower installation
Page
3-2