User's Manual Part 1
Table Of Contents
- Cambium PTP 650 Series User Guide
- Contacting Cambium Networks
- Purpose
- Cross references
- Feedback
- Chapter 1: Product description
- Chapter 2: System hardware
- Chapter 3: System planning
- Chapter 4: Legal and regulatory information
- Cambium Networks end user license agreement
- Acceptance of this agreement
- Definitions
- Grant of license
- Conditions of use
- Title and restrictions
- Confidentiality
- Right to use Cambium’s name
- Transfer
- Updates
- Maintenance
- Disclaimer
- Limitation of liability
- U.S. government
- Term of license
- Governing law
- Assignment
- Survival of provisions
- Entire agreement
- Third party software
- Compliance with safety standards
- Compliance with radio regulations
- Cambium Networks end user license agreement
Chapter 2: System hardware Ethernet cabling
Drop cable tester
The drop cable tester is an optional item for testing the resistances between the RJ45 pins of the
drop cable (Figure 19). Order it by completing the order form on the support website (see
Contacting Cambium Networks on page 1).
Figure 19
Drop cable tester
Indoor Cat5e cable
To connect the PSU to network terminating equipment, use indoor Cat5e cable. The ODU network
connection implements automatic MDI/MDI-X sensing and pair swapping, allowing connection to
networking equipment that requires cross-over cables (MDI-X networks) or straight-through cables
(MDI Networks).
Page
2-34