User's Manual Part 1
Table Of Contents
- Cambium PTP 650 Series User Guide
- Contacting Cambium Networks
- Purpose
- Cross references
- Feedback
- Chapter 1: Product description
- Chapter 2: System hardware
- Chapter 3: System planning
- Chapter 4: Legal and regulatory information
- Cambium Networks end user license agreement
- Acceptance of this agreement
- Definitions
- Grant of license
- Conditions of use
- Title and restrictions
- Confidentiality
- Right to use Cambium’s name
- Transfer
- Updates
- Maintenance
- Disclaimer
- Limitation of liability
- U.S. government
- Term of license
- Governing law
- Assignment
- Survival of provisions
- Entire agreement
- Third party software
- Compliance with safety standards
- Compliance with radio regulations
- Cambium Networks end user license agreement
Chapter 2: System hardware Power supply units (PSU)
Table 12
AC+DC Enhanced Power Injector
specifications
Category
Specification
Dimensions 250 mm (9.75 in) x 40 mm (1.5 in) x 80 mm (3 in)
Weight 0.864 Kg (1.9 lbs)
Temperature -40°C (-40°F) to +60°C (140°F)
Humidity 0 to 90% non-condensing
Waterproofing Not waterproof
AC Input 90-264 V AC, 47-60 Hz
Alternative DC Input 37-60 V DC
DC Output Voltage
For mains input: 58 V, +2V, -0V
For DC input: Output voltage at maximum rated output
current, not more than 1.5 V below the DC input voltage.
Maximum length of DC output cable: 3 meters.
AC Input connector IEC-320-C8
DC Output current 1.7A
Efficiency Better than 84%
Over Current Protection Hiccup current limiting, trip point set between 120% to
150% of full load current
Hold up time At least 20 milliseconds
Power factor Better than 0.9
Page
2-14