User's Manual Part 1
Table Of Contents
- Cambium PTP 650 Series User Guide
- Contacting Cambium Networks
- Purpose
- Cross references
- Feedback
- Chapter 1: Product description
- Chapter 2: System hardware
- Chapter 3: System planning
- Chapter 4: Legal and regulatory information
- Cambium Networks end user license agreement
- Acceptance of this agreement
- Definitions
- Grant of license
- Conditions of use
- Title and restrictions
- Confidentiality
- Right to use Cambium’s name
- Transfer
- Updates
- Maintenance
- Disclaimer
- Limitation of liability
- U.S. government
- Term of license
- Governing law
- Assignment
- Survival of provisions
- Entire agreement
- Third party software
- Compliance with safety standards
- Compliance with radio regulations
- Cambium Networks end user license agreement
Chapter 2: System hardware Outdoor unit (ODU)
Table 5
ODU mounting bracket part numbers
Pole diameter
ODU type
Cambium description
Cambium part
number
From
50 to 75 mm
(2 to 3 inches)
Integrated PTP 650 Mounting Bracket
(integrated)
N000065L031
Connectorized PTP 650 Mounting Bracket
(connectorized)
N000065L032
Either 90 mm (3.5 inches)
or 115 mm (4.5 inches)
Integrated and
connectorized
Extended Diameter Mast
mounting kit 3.5” and 4.5”
N000065L030
ODU interfaces
The PSU, AUX and SFP ports are on the rear of the integrated and connectorized ODUs (Figure 10).
These interfaces are described in Table 6. Each of the PSU, AUX and SFP ports can be configured
to disable Ethernet traffic or to carry the following Ethernet traffic:
• Wireless bridge data
• Wireless bridge data and in-band management
• Out-of-band local management
• Local loop-back between any two ports
Figure 10
ODU rear interfaces
Page
2-7