User's Manual Part 1
Table Of Contents
- Cambium PTP 650 Series User Guide
- Contacting Cambium Networks
- Purpose
- Cross references
- Feedback
- Chapter 1: Product description
- Chapter 2: System hardware
- Chapter 3: System planning
- Chapter 4: Legal and regulatory information
- Cambium Networks end user license agreement
- Acceptance of this agreement
- Definitions
- Grant of license
- Conditions of use
- Title and restrictions
- Confidentiality
- Right to use Cambium’s name
- Transfer
- Updates
- Maintenance
- Disclaimer
- Limitation of liability
- U.S. government
- Term of license
- Governing law
- Assignment
- Survival of provisions
- Entire agreement
- Third party software
- Compliance with safety standards
- Compliance with radio regulations
- Cambium Networks end user license agreement
Chapter 1: Product description Overview of the PTP 650
Typical bridge deployment
The PTP 650 is an “all outdoor” solution consisting of a wireless bridge between two sites. Each
site installation consists of an integrated or connectorized outdoor unit (ODU) and a power injector
(PSU) (Figure 1). The ODU provides the following interfaces:
• PSU port: This provides proprietary power over Ethernet and connection to the management
and/or data networks via 100BASE-TX or 1000BASE-T Ethernet. In the basic configuration, this
is the only Ethernet connection to the ODU.
• SFP port: This provides an optical or copper Gigabit Ethernet interface for out-of-band local
management, user data or user data with in-band management.
• Aux port: This provides an optional power and 100BASE-TX or 1000BASE-T Ethernet
connection to an IEEE803.2at device such as a video camera or wireless access point.
Figure 1
PTP 650 typical bridge deployment
Page
1-4