User's Manual Part 1
Table Of Contents
- Cambium PTP 650 Series User Guide
- Contacting Cambium Networks
- Purpose
- Cross references
- Feedback
- Chapter 1: Product description
- Chapter 2: System hardware
- Chapter 3: System planning
- Chapter 4: Legal and regulatory information
- Cambium Networks end user license agreement
- Acceptance of this agreement
- Definitions
- Grant of license
- Conditions of use
- Title and restrictions
- Confidentiality
- Right to use Cambium’s name
- Transfer
- Updates
- Maintenance
- Disclaimer
- Limitation of liability
- U.S. government
- Term of license
- Governing law
- Assignment
- Survival of provisions
- Entire agreement
- Third party software
- Compliance with safety standards
- Compliance with radio regulations
- Cambium Networks end user license agreement
Chapter 3: System planning Security planning
If the vendor-specific auth-role attribute is absent, but the standard service-type (Type 6) attribute
is present, PTP 650 selects the role for the authenticated user according to service-type. The
supported values of service-type are as follows:
• Login(1): Read Only
• Administrative(6): System Administrator
• NAS Prompt(7): Read Only
If the auth-role and service-type attributes are absent, PTP 650 selects the Read Only role.
The auth-role vendor-specific attribute is defined in Table 40.
Table 40
Definition of auth-role vendor-specific attribute
Field
Length
Value
Notes
Type 1 26 Vendor-specific attribute.
Length 1 12 Overall length of the attribute.
Vendor ID 4 17713 The same IANA code used for the SNMP enterprise
MIB.
Vendor Type 1 1 auth-role
Vendor Length 1 4 Length of the attribute specific part.
Attribute-
Specific
4 0..3 Integer type (32-bit unsigned). Supported values:
invalid-role(0), readonly-role(1), system-admin-role(2),
security-officer-role(3).
Page
3-40