User's Manual Part 1
Table Of Contents
- Cambium PTP 650 Series User Guide
- Contacting Cambium Networks
- Purpose
- Cross references
- Feedback
- Chapter 1: Product description
- Chapter 2: System hardware
- Chapter 3: System planning
- Chapter 4: Legal and regulatory information
- Cambium Networks end user license agreement
- Acceptance of this agreement
- Definitions
- Grant of license
- Conditions of use
- Title and restrictions
- Confidentiality
- Right to use Cambium’s name
- Transfer
- Updates
- Maintenance
- Disclaimer
- Limitation of liability
- U.S. government
- Term of license
- Governing law
- Assignment
- Survival of provisions
- Entire agreement
- Third party software
- Compliance with safety standards
- Compliance with radio regulations
- Cambium Networks end user license agreement
Chapter 3: System planning Network management planning
Network management planning
This section describes how to plan for PTP 650 links to be managed remotely using SNMP.
Planning for SNMP operation
The supported notifications are as follows:
• Cold start
• Wireless Link Up/Down
• Channel Change
• DFS Impulse Interference
• Authentication Failure
• Main PSU Port Up Down
• Aux Port Up Down
• SFP Port Up Down
Ensure that the following MIBs are loaded on the network management system.
• RFC-1493. BRIDGE-MIB
• RFC-2233. IF-MIB
• RFC-3411. SNMP-FRAMEWORK-MIB
• RFC-3412. SNMP-MPD-MIB
• RFC-3413. SNMP-TARGET-MIB
• RFC-3414. SNMP-USER-BASED-SM-MIB
• RFC-3415. SNMP-VIEW-BASED-ACM-MIB
• RFC-3418. SNMPv2-MIB
• RFC-3826. SNMP-USM-AES-MIB
• RFC-4293 IP-MIB
• PTP 650 Series proprietary MIB
Note
The proprietary MIBs are provided in the PTP 650 Series software download files in
the support website (see Contacting Cambium Networks on page 1).
Page
3-31