Installation Guide
Table Of Contents
- PMP 450i and PTP 450i Configuration and User Guide
- Safety and regulatory information
- Contents
- List of Figures
- List of Tables
- About This Configuration and User Guide
- Chapter 1: Reference information
- Chapter 2: Configuration
- Preparing for configuration
- Task 1: Connecting to the unit
- Task 2: Configuring IP and Ethernet interfaces
- Configuring the AP IP interface
- NAT, DHCP Server, DHCP Client and DMZ in SM
- Configuring the SM IP interface with NAT disabled
- Configuring the SM IP interface with NAT enabled
- NAT tab of the SM with NAT disabled
- NAT tab of the SM with NAT enabled
- Reconnecting to the management PC
- VLAN Remarking and Priority bits configuration
- VLAN tab of the AP
- VLAN tab of the SM
- VLAN Membership tab of the SM
- PPPoE tab of the SM
- NAT Port Mapping tab of the SM
- Task 3: Upgrading the software version and using CNUT
- Task 4: Configuring General and Unit settings
- Task 5: Configuring security
- Isolating APs from the internet
- Encrypting radio transmissions
- Managing module access by passwords
- Requiring SM Authentication
- Filtering protocols and ports
- Encrypting downlink broadcasts
- Isolating SMs
- Filtering management through Ethernet
- Allowing management only from specified IP addresses
- Configuring management IP by DHCP
- Restricting radio Telnet access over the RF interface
- Security tab of the AP
- Filtering protocols and ports
- Protocol Filtering tab of the AP
- Port configuration tab of the AP
- Security tab of the SM
- Protocol Filtering tab of the SM
- Port Configuration tab of the SM
- Task 6: Configuring radio parameters
- Task 7: Setting up SNMP agent
- Task 8: Configuring syslog
- Task 9: Configuring remote access
- Task 10: Monitoring the AP-SM Link
- Task 11: Configuring quality of service
- Maximum Information Rate (MIR) Parameters
- Token Bucket Algorithm
- MIR Data Entry Checking
- Committed Information Rate (CIR)
- Bandwidth from the SM Perspective
- Interaction of Burst Allocation and Sustained Data Rate Settings
- High-priority Bandwidth
- Traffic Scheduling
- Setting the Configuration Source
- Quality of Service (QoS) tab of the AP
- DiffServ tab of the AP
- Quality of Service (QoS) tab of the SM
- DiffServ tab of the SM
- Task 12: Performing an Sector Wide SA
- Task 13: Zero Touch Configuration Using DHCP Option 66
- Task 14: Configuring Radio via config file
- Task 15: Configuring a RADIUS server
- Understanding RADIUS for PMP 450i
- Choosing Authentication Mode and Configuring for Authentication Servers - AP
- SM Authentication Mode – Require RADIUS or Follow AP
- Handling Certificates
- Configuring your RADIUS servers for SM authentication
- Assigning SM management IP addressing via RADIUS
- Configuring your RADIUS server for SM configuration
- Using RADIUS for centralized AP and SM user name and password management
- RADIUS Device Data Accounting
- RADIUS Device Re-authentication
PMP 450i and PTP 450i Configuration and User Guide List of Figures
Figure 41 Multicast VC statistics ......................................................................................... 117
Figure 42 Multicast scheduler statistics .............................................................................. 117
Figure 43 DiffServ tab on AP and SM .................................................................................. 120
Figure 44 Protocol filtering tab on AP and SM (Packet Filter Configuration section) ....... 122
Figure 45 Radio tab of the SM for 5 GHz ............................................................................. 123
Figure 46 Speedtest results example with 1 AP and 1 SM .................................................. 132
Figure 47 SNMP tab of the AP ............................................................................................ 135
Figure 48 SNMP tab of the SM ............................................................................................ 139
Figure 49 AP Syslog Configuration page ............................................................................. 145
Figure 50 SM Syslog Configuration page ............................................................................ 146
Figure 51 SM IP Configuration page .................................................................................... 148
Figure 52 AP Session Status page ........................................................................................ 150
Figure 53 AP Remote Subscribers page ............................................................................... 150
Figure 54 AP Session Status page ....................................................................................... 151
Figure 55 Exporting Session Status page of the AP ........................................................... 153
Figure 56 Uplink and downlink rate caps adjusted to apply aggregate cap ....................... 155
Figure 57 Uplink and downlink rate cap adjustment example ............................................ 155
Figure 58 Quality of Service (QoS) tab of the AP ................................................................. 161
Figure 59 Diffserv tab of the AP ........................................................................................... 163
Figure 60 Quality of Service (QoS) tab of the SM ................................................................ 165
Figure 61 DiffServ tab of the SM ......................................................................................... 168
Figure 62 Spectrum Analyzer tab of the AP/ SM ................................................................ 171
Figure 63 Remote Spectrum Analyzer tab of the AP .......................................................... 174
Figure 64 Configuration File upload and download page ................................................... 183
Figure 65 Security tab of the AP .......................................................................................... 186
Figure 66 Security tab of the SM ......................................................................................... 191
Figure 67 SM Certificate Management ................................................................................ 198
Figure 68 User Authentication and Access Tracking tab of the AP .................................... 205
Figure 69 User Authentication and Access Tracking tab of the SM ................................... 207
Figure 70 RADIUS accounting messages configuration ..................................................... 211
Figure 71 Device re-authentication configuration ............................................................... 212
xii
pmp-0957 (April 2015)