Installation Guide

PMP 450i and PTP 450i Configuration and User
Task 5: Configuring security
SNMPv3 Read-Only and Read/Write User
The user can defined by configurable attributes. The attributes and default
values are:
• Read-only user
o Username = Canopyro
o Authentication Password = authCanopyro
o Privacy Password = privacyCanopyro
• Read-write user (by default read-write user is disabled)
o Username = Canopy
o Authentication Password = authCanopy
o Privacy Password = privacyCanopy
SNMPv3 Trap Configuration
The traps may be sent from radios in SNMPv3 format based on parameter
settings. It can be configured for Disabled, Enabled for Read-Only User, Enable
for Read/Write User.
Restricting AP RF Telnet Access
AP Telnet access via the RF interface may be configured in two ways – the AP GUI
and SNMP.
Controlling RF Telnet Access via the AP GUI
To restrict all Telnet access to the AP via the RF interface from downstream devices,
follow these instructions using the AP GUI:
Procedure 10 Restricting RF Telnet access
1
Log into the AP GUI using administrator credentials
2
On the AP GUI, navigate to Configuration => Protocol Filtering
3
Under GUI heading “Telnet Access over RF Interface”, set RF Telnet Access to
Disabled
4
Click the Save button
5
Once the Save button is clicked, all RF Telnet Access to the AP from devices
situated below the AP is blocked.
92 pmp-0957 (April 2015)