Installation Guide

Task 5: Configuring security PMP 450i and PTP 450i Configuration and User
Guide
From the factory default state, configure passwords for both the root and admin
account at the ADMINISTRATOR permission level, using the Account, Change Users
Password tab. To change the user password, select the desired user and enter the
new password in the “New Password” field. This new password must be confirmed
in the “Confirm Password” field. To commit the password change, click "Change
Password" (If you configure only one of these, then the other will still require no
password for access into it and thus remain a security risk). If you are intent on
configuring only one of them, delete the admin account. The root account is the only
account that CNUT uses to update the module.
The User Mode is used to create an account which are mainly used for viewing the
configurations. The local and remote Read-Only user account can be created by
“Admin”, “Installer” or “Tech” logins. To create a Read-Only user, the “read-only”
check box needs to be checked.
The Read-Only user cannot perform any service impacting operations like creating
read-only accounts, editing and viewing read-only user accounts, changes in login
page, read-only user login, Telnet access, SNMP, RADIUS and upgrade/downgrade.
Figure 26 AP / SM Add User tab of account page
After a password has been set for any ADMINISTRATOR-level account, initial access
to the module GUI opens the view of GUEST level.
Deleting a User from Access to a Module
The Account => Delete User tab provides a drop down list of configured users
from which to select the user you want to delete.
Figure 27 Delete User tab of the AP / SM
pmp-0957 (April 2015) 81