User's Manual

Table Of Contents
8 Web Page Reference
162
8.3.4 Install Pages
The
se pages are used during system installation. There follows a description of the install
pages along with their use during the installation configuration process. The actual installation
process is described in Section 8.3.4.1 “Manually Configuring The Wireless Units”.
NOTE
: This section assumes that the integrated PTP 600 is being installed. If the
connectorized variant is being installed, refer to Section 13.3 “Software/Features” for details
of the additio
nal functionality that must be configured.
All wireless links are shipped as paired units. They are pre-configured at the factory so that
they can be installed without the user supplying any configuration. Each wireless link is
shipped with a quick start guide. Attached to the quick start guide is a summary of the pre-
configured configuration data. Table 35 shows a sample link configuration. The values in
red
type have been committed to the wireless unit’s non-volatile storage.
Table 35 – 600 Series Bridge Factory Configuration Values
Example PTP 600 Series Configuration Data
For your convenience these two units have been pre-configured as a link
Units:
ODU serial number ODU serial number
016780000FFF 016780000FC7
Ethernet MAC address Ethernet MAC address
00:04:56:80:0F:FF 00:04:56:80:0F:C7
Configured as:
Master Slave
Target MAC address Target MAC address