Installation guide

96107 Fourth Edition 25
StorageTek Proprietary
Overview
The command lsdev –Cc adapter will display a list of installed adapters. It will
look like this:
AIXPCI3/> lsdev -Cc adapter
sa0 Available 01-S1 Standard I/O Serial Port
sa1 Available 01-S2 Standard I/O Serial Port
sa2 Available 01-S3 Standard I/O Serial Port
siokma0 Available 01-K1 Keyboard/Mouse Adapter
fda0 Available 01-D1 Standard I/O Diskette Adapter
scsi0 Available 10-60 Wide SCSI I/O Controller
scsi1 Available 10-68 Wide/Fast-20 SCSI I/O Controller
scsi2 Available 10-70 Wide/Fast-20 SCSI I/O Controller
scsi3 Available 30-58 Wide SCSI I/O Controller
mga0 Available 30-68 GXT120P Graphics Adapter
sioka0 Available 01-K1-00 Keyboard Adapter
ppa0 Available 01-R1 Standard I/O Parallel Port Adapter
ent0 Available 10-78 IBM 10/100 Mbps Ethernet PCI Adapter (23100020)
ent1 Available 10-80 IBM PCI Ethernet Adapter (22100020)
sioma0 Available 01-K1-01 Mouse Adapter
fscsi5 Available 30-60 Cambex Fibre Channel I/O Controller
fcs0 Available 20-58 FC Adapter
The HBAs (fcs(n) for IBM HBAs, or fscsi(n) for Cambex HBAs) should show as
“Available”. If not for Cambex HBAs, check for correct driver installation by
using lslpp –l PC1000.driver.image. This will show if installed and
version.
AIXPCI3/> lslpp -l PC1000.driver.image
Fileset Level State Description
----------------------------------------------------------------------------
Path: /usr/lib/objrepos
PC1000.driver.obj 2.5.10.5 COMMITTED PC1000 Fibre Channel
Adapter Driver (AIX 5L)
If this is good, check that HBA(s) are correctly seated, defective, etc.