Operators Manual Model 1000WM 1500WM 1000WM/SS 1500WM/SS 1500WM/SS3 2000WM/SS 2000WM/SSM3 2020WM/SS 3000WM/SS 3000WM/SSM3 8535WM/SS-CM 8535WM/SS3-CM 1000WM/SS3-CM PSI 1000 1500 1000 1500 1500 2000 2000 2000 3000 3000 850 850 1000 GPM 2.2 3.0 2.2 3.0 3.0 4.0 4.0 2.0 4.0 4.0 3.5 3.5 2.2 HP 1.5 3 1.5 3 3 5 5 3 7.5 7.5 2 2 1.5 510504.
Thank you Thank you for selecting our products. Our personnel have proudly made every effort to ensure that your new pressure washer is of the quality you expect. But things do occasionally go wrong. This is why every pressure washer is covered by a limited warranty. Among other things, this warranty provides for the replacement of parts found to be defective during the operation of your new pressure washer. Please note that the owner/operator has certain obligations under the terms of the warranty.
Statement of Warranty The manufacturer of this product agrees to repair or replace designated parts that prove defective within the warranty period listed in the chart below. Specific limitations and exclusions apply. This warranty covers defects in material and workmanship and not failure due to normal wear, depreciation, abuse, accidental damage, negligence, improper use, maintenance or storage.
WARNING The following warnings must be followed, Failure to follow these warnings could result in serious personal injury or death! Never allow children or untrained personnel to operate machinery. Electrical equipment can cause shock and sparks. Do not bypass or remove the grounding prong in any electrical plug. Keep electrical plugs, connections and cords out of water and moisture. Refer to instructions prior to equipment operation. Disconnect from power source before servicing.
Initial setup and operation of your new pressure washer Inspection for freight damage. When you receive your pressure washer be sure you check for concealed freight damage. Any damage should be noted with the delivering carrier. If you have any questions related to freight call the 800 number listed in the front of the manual. Inspection Check all oil levels in the pump or engine if applicable. Failure to check all levels will result in of oil levels equipment damage.
During Operation The pressure was set at the factory during the testing procedure, no adjustments to the machine should be required for operation. During operation do not leave the machine running for more than 2 minutes without the trigger gun being pulled. Although your machine has a by-pass valve on it and may have a thermal relief system, this can cause extensive pump damage. If machine will not be discharging water for more than 2 minutes, shut the machine off.
Shut down procedure Storage 1. Turn off the power switch on the pressure washer. 2. Relieve pressure on line by pulling trigger gun. 3. Shut off water supply and disconnect garden hose. 4. Be sure to check for water leaks or oil leaks that should be repaired before the next operation. 5. If you are going to store the machine for extended period of times in cold climates be sure to antifreeze the equipment.
Mounting plate 8
Wall mount Gun Wand Assemblys Twist-fast socket (527800) Gun section (AR AL200) Soap tip (4030 1/4 meg) Forward grip/soap control valve. Activates chemical injector by lowering pressure and allowing water to go through soap tip.
