User Manual

The ULP Pro is engineered to be a robust device with
minimal downtime. This new shape has been
designed for optimum water spillage which implies
lower probability of ice formation. Frost might
affect measurements if it blocks the wave path.
The input wires are protected by Transient Voltage
Suppression (TVS) diodes. The instrument
body is inject molded.
Every single unit is calibrated with accuracy, following the
same calibration standards for each one in a
wind tunnel.
A Q/C report for both wind speed and direction is genera-
ted and kept in our files. Standard deviation is checked to
guarantee that each unit has been calibrated to the
highest standards.
4. Configuration Options
The ULP Pro can be set up by using a special configurator
App made by Calypso Instruments.
In order to use the app you should download the
configurator from our website at
www.calypsoinstruments.com.
To configure your device, connect the ULP Pro via either a
USB to RS485 converter cable (in case of the ULP Pro
RS485 or the ULP Pro Modbus) or via a USB to UART
converter cable (in case of the ULP Pro UART). Connect all
the ULP Pro cables except for the brown cable to the
converter. Insert the USB into the computer, open the
configurator app, select the configuration wanted and
follow the instructions on the screen to finish the configu-
ration.
For more information, please watch the following video.
https://bit.ly/3DuA7lM
*USB converter cables available on calypsoinstruments.-
com
ULP Pro User manual
NEW!
06/08
Upgradable RS485, MODBUS or
UART/TTL configurator tool available
on our website for downloading in the
section Technical Information.
3.9 Product Material
3.10 Quality Control
baudrate:
output rate:
output units:
0.5 to 10 Hertz
m/sec., knots or km/h
2400 to 115200 (8n1) bauds
3.8. Firmware