User Manual

3. Technical specifications
The ULP has the following technical specifications:
The ULP has to be connected as shown in this section.
3.1. Dimensions
· Diameter: 68 mm (2.68 in.)
· Height: 65 mm (2.56 in.)
3.2. Weight
200 grams (7 ounces)
3.3 Power
· 3.3-18 DCV
3.4. Sensors
Ultrasonic transducers (4x)
Sample rate: 0.5 Hz to 10 Hz
04/08
ULP Pro User manual
1Stream
2-POLL
3-MODBUS
NMEA0183
2400 to 115200 bauds
3.3-18V
Data interface
Data format
Baudrate
Voltage range
RS485/MODBUS RTU Output:
,
UART/TTL Output:
Power consumption:
(RS485) 0.25 mA at 38400 bauds, 1 Hz. (5V)
(UART) 0.15 mA at 38400 bauds, 1 Hz. (5V)
(MODBUS) 0.25 mA at 38400 bauds, 1 Hz. (5V)
The ULP has been designed to avoid any mechanical
parts to maximize reliability and minimize maintenance.
The transducers communicate between themselves two
by two using ultrasonic range waves. Each pair of trans-
ductors calculates the signal delay and get information
about both wind direction and wind speed.
Brown
VCC (Power +)
White
GND (Power -)
Green
DATA Tx
Yellow
DATA Rx
Brown
VCC (Power +)
White
GND (Power -)
Green
DATA (A +)
Yellow
DATA (B -)