Quick Reference Guide
Table Of Contents
- 1Unpacking and Checking
- 2Radio Overview
- 3Operations
- 4CPS-Menu
- 5Common Setting
- 6Conventional Setting
- 6.1.1Conventional Setting-Password
- 6.1.2Conventional Setting-Zone
- 6.1.3Conventional Setting-Channel-Digital Channel
- 6.1.4Conventional Setting-Channel-Analog Channel
- 6.1.5Conventional Setting-Multi CTC/CDC
- 6.1.6Conventional Setting-Contact
- 6.1.7Conventional Setting-Network-Network
- 6.1.8Conventional Setting-Network- Local Access Managem
- 6.1.9Conventional Setting-Network-Multisite Access Mana
- 6.1.10Conventional Setting-Network-Application Programmi
secret▲
All rights reserved.No spreading abroad without permission of Caltta.
13
4.3Program
The Program menu includes the following functions:
Submenu
Description
Shortcut
Key
Read
This function reads data from your Repeater. After
powering on your Repeater, connect it to a PC and select
Program > Read. The Read dialog box is displayed. Click
OK to read data. During the data reading process, a
progress bar is displayed to show the progress. After
programming data is read completely, a message box is
displayed, showing that data is read successfully.
Ctrl+R
Write
This function writes data into your Repeater. After
powering on your Repeater, connect it to a PC through a
USB cable and select Program > Write from the menu.
The Write dialog box is displayed. Click OK to write data.
During the data writing process, a progress bar is
displayed to show the progress. After programming data is
written completely, a message box is displayed, showing
that data is written successfully. Your radio will be
restarted automatically and then use the new configuration
data.
Ctrl+W
USB Port
This function allows you to select the port device for this
operation.
/
Restore
Factory
Defaults
This function restores all parameter settings of your
Repeater to the default values.
/
Clone
This function replicates the configured data to a target
Repeater. After powering on your Repeater, connect it to a
PC and select Program > Clone from the menu. The Clone
dialog box is displayed, asking you to select the target
/